Installing Hardware Options
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide 3-17
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: d-ch03 Installing Hardware Options.doc
Codename: Dizzy Devil Part Number: 281992-002 Last Saved On: 12/3/02 12:45 PM
NOTE: On the tower server, open the front bezel to access the Power On/Standby
button.
Figure 3-14: Pressing the Power On/Standby button
(tower server)
6. Disconnect all power cords from the server.
7. Disconnect all peripheral cables from the server rear panel, including cables
extending from external connectors on expansion boards.
The system is now without power and you can safely install all hardware options.
NOTE: It is not necessary to remove power from the server before installing hot-plug
components.
To Next Page
Loading...
