Installing the Rack Server
4-16 HP ProLiant ML370 Generation 3 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: e-ch04 Installing the Rack Server.doc
Codename: Dizzy Devil Part Number: 281992-002 Last Saved On: 12/3/02 2:12 PM
3. Thread the power cord through the retaining clip.
4. Flip the lower tab up toward the chassis until it snaps into place to secure the
power cord.
Figure 4-14: Securing the power cord in the retaining
clip
CAUTION: After securing the power cord and before powering up the server, always
extend and retract the server to be sure that the cords remain connected when the
server is at full extension.
To Next Page
Loading...
