Installing Hardware Options
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide 3-43
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: d-ch03 Installing Hardware Options.doc
Codename: Dizzy Devil Part Number: 281992-002 Last Saved On: 12/3/02 12:45 PM
2. Remove the access panel. Refer to “Removing the Access Panel” in this chapter.
CAUTION: Always populate each media bay with either a drive or blank. Proper
airflow can only be maintained when the bays are populated. Unpopulated drive
bays can lead to improper cooling and thermal damage.
NOTE: HP recommends that you move the CD-ROM drive out of the media cabling area
for ease of installation. It is not necessary to disconnect and remove the CD-ROM drive
from the server entirely.
3. Press and hold the sliding media latch to release the bezel blanks (1) while
pushing the blanks from behind to remove (2).
NOTE: Removing both bezel blanks is not always necessary, but makes installation and
cabling easier.
Figure 3-33: Removing bezel blanks
4. Store the blanks for later use.
To Next Page
Loading...
