Installing Hardware Options
HP ProLiant ML370 Generation 3 Server Setup and Installation Guide 3-49
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: d-ch03 Installing Hardware Options.doc
Codename: Dizzy Devil Part Number: 281992-002 Last Saved On: 12/3/02 12:45 PM
4. Use the Torx T-15 tool provided with the server to remove the four installation
screws from the bezel blanks.
Figure 3-39: Removing installation screws from a bezel
blank
IMPORTANT: Each SCSI device in the server must have a unique address. The server
automatically sets all SCSI IDs for hot-plug drives, but you must set the SCSI IDs for
devices installed in the media cage.
5. Set the SCSI ID for the non-hot-plug SCSI hard drive. Refer to the
documentation that ships with the hard drive.
To Next Page
Loading...
