3. Change the RBSU settings, as described in RBSU settings (page 22). Save the changes
and exit.
4. Let the operating system complete its boot.
5. Check that an existing iLO4 Advanced license is loaded. If it is not, add it:
1. Log on to the iLO4 GUI.
2. Select the Administration Tab.
3. Select Licensing and enter the recorded license key in the section marked Enter
License Activation Key.
6. Use the StoreOnce GUI or StoreOnce CLI to check that the firmware on the new component
is correct.
NOTE: Note the output at command completion. It will advise if you need a system reboot
or a cold reboot to install the new firmware revision successfully.
7. After power-up, it is necessary to rewrite warranty serial numbers into BIOS. Contact HPE
Support for assistance in rewriting warranty serial numbers. Once this task has been done,
use the Rescan button on the Remote Support page of the StoreOnce GUI to view the
warranty details. (Or use the StoreOnce CLI command, system scan devices.)
More information
RBSU settings (page 22)
iLO4 settings (page 23)
Upgrading BIOS or hardware firmware (page 13)
RBSU settings
Change the RBSU settings, as shown in the following table.
NOTE: Unless noted otherwise, the settings apply to all products.
22 System motherboard replacement
To Next Page
Loading...
Need help?
General
