HPE StoreOnce 4700 Backup server
The HPE StoreOnce 4700 Backup system consists of a server unit (with two disks) and one disk
enclosure on which storage has already been expanded. It supports connection of up to seven
additional storage enclosures (Capacity Upgrade Kits); storage must be expanded when Capacity
Upgrade Kits are added to the base configuration. All storage enclosures have 12 x 2 TB disks.
Figure 16 Front view of the HPE StoreOnce 4700 Backup system
Steady green: Hardware is performing correctly1. System Health LED
Flashing amber: degraded condition
Flashing red: critical condition, such as power supply or fan failure
Off: no network connection or network not configured2. NIC status LED
Steady green: network connected
Flashing green: network activity
Steady green: Power connected, device ready to use3. Power On button/LED
Flashing green: performing power on sequence
Steady amber: Device switched off or in hibernation with power connected
Steady blue: identifies the unit
Off: No power connected
Steady blue identifies the StoreOnce Backup system in the rack.4. UID button
Flashing blue: remote management or firmware upgrade in progress
The HP systems Insight Display LEDs represent the system board layout and
may be useful for troubleshooting.
5. System Insight Display
These drives contain the operating system and filesystem. They are not used
for data storage.
6. Hot plug drives
The following figure illustrates the rear view of the server.
HPE StoreOnce 4700 Backup server 41
To Next Page
Loading...
