Installing the compute moduleInstalling the compute module
ProcedureProcedure
1. Verify that the device bay is configured for a half-height compute module. For more information, see the setup and installation
guide for the frame on the Hewlett Packard Enterprise websiteHewlett Packard Enterprise website .
2. Remove the compute module end cap.
3. Prepare the compute module for installation by opening the compute module handle
4. Install the compute module.
Slide the compute module until it is fully inserted in the enclosure slot. Rotate the handle until it latches.
5. Review the compute module front panel LEDs to determine the compute module status. For more information on the compute
module LEDs, see " Component identification."
To remove the component, reverse the installation procedure.
To Next Page
Loading...
