Front panel LEDs and buttonsFront panel LEDs and buttons
ItemItem DescriptionDescription StatusStatus
1 UID LED Solid blue = Activated
Flashing blue (1 Hz/cycle per sec) = Remote management or
firmware upgrade in progress
Off = Deactivated
2 Health status LED Solid green = Normal
Flashing green (1 Hz/cycle per sec) = iLO is rebooting.
Flashing amber = System degraded
Flashing red (1 Hz/cycle per sec) = System critical
3 Mezzanine NIC status LED Solid green= Link on any Mezzanine NIC
Flashing green= Activity on any Mezzanine NIC
Off = No link or activity on any Mezzanine NIC
4 Power On/Standby button and system power
LED
Solid green = System on
Flashing green (1 Hz/cycle per sec) = Performing power on
sequence
Solid amber = System in standby
Off = No power present
NOTE:NOTE:
If all other LEDs are off, no compute module power is
present (facility power is not present, power cord is
not attached, power supplies are not installed, power
supply failure has occurred, or the power button
cable is disconnected). If the health LED is flashing
green while the system power LED is off, the PowerPower
On/StandbyOn/Standby button service is initializing or an iLO
reboot is in progress.
To Next Page
Loading...
