HP Synergy 480 Gen10 - Table of Contents

Table of contentsTable of contents
1 Component identification
1.1 Front panel components
1.1.1 Serial label pull tab information
1.2 Front panel LEDs and buttons
1.3 Drive numbering
1.4 Smart Carrier (SC) drive LED definitions
1.5 SFF flash adapter components and LED definitions
1.6 Smart Carrier NVMe (SCN) drive LED definitions
1.7 System board components
1.7.1 System maintenance switch
1.7.2 Processor, heatsink, and socket components
1.7.3 Mezzanine connector definitions
1.7.4 DIMM slot locations
1.7.5 DIMM label identification
1.7.6 NVDIMM identification
1.7.6.1 NVDIMM 2D Data Matrix barcode
1.7.7 NVDIMM LED identification
1.7.7.1 NVDIMM-N LED combinations
1.7.7.2 NVDIMM Function LED patterns
1.7.8 Intel Optane persistent memory 100 series for HPE label identification
1.7.9 Enterprise Midline USB
1.7.10 LEDs
1.8 Component and LED identification for HPE Synergy hardware
2 Operations
2.1 Powering up the compute module
2.2 Powering down the compute module
2.3 Removing the drive blank
2.4 Removing the compute module
2.5 Removing the compute module end cap
2.6 Removing the access panel
2.7 Removing the DIMM baffle
2.8 Removing the front panel/drive cage assembly
2.9 Installing the compute module end cap
2.10 Installing the access panel
2.11 Installing the DIMM baffles
2.12 Installing the front panel/drive cage assembly
3 Setup
3.1 Installation overview
3.2 Installing the compute module
3.3 Completing the configuration
4 Hardware options installation
4.1 Introduction