Installing the M.2 SSD flash drive and adapter boardInstalling the M.2 SSD flash drive and adapter board
PrerequisitesPrerequisites
To complete this procedure, you need a No. 1 Phillips screwdriver.
ProcedureProcedure
1. Power down the compute module.
2. Remove the compute module.
3. Lay the compute module on a flat and level surface.
4. Remove the access panel .
5. Remove the front panel/drive cage assembly .
6. Locate the SSD adapter board, and install SSD flash drive onto the adapter card.
IMPORTANT:IMPORTANT:
Install the SSD flash drive into the connector at an angle first, and then lower it down onto the adapter card
mounting standoffs to ensure proper installation.
7. Secure the SSD flash drive to the adapter board, screwing the SSD flash drive screw into the adapter board standoff.
8. Repeat the SSD flash drive installation on the second SSD flash drive, as applicable.
9. Install the SSD adapter board onto the compute module system board.
a. Install the SSD adapter board to the system board adapter housing at an angle. Make sure that you align the adapter card edges
to the edge slots and the alignment pins near the front of the compute module.
To Next Page
Loading...
