Installing the SFF flash adapter optionInstalling the SFF flash adapter option
CAUTION: CAUTION: To prevent improper cooling and thermal damage, do not operate the compute module or the enclosure
unless all drive and device bays are populated with either a component or a blank.
PrequisitesPrequisites
The SFF flash adapter option is supported when any of the following components are installed:
HPE Dynamic Smart Array S100i Controller
HPE Smart Array E208i-c/P204i-c/P416ie-m Controller
HPE Synergy 3830C 16G FC HBA
HPE Synergy 3530C 16G FC HBA
ProcedureProcedure
1. Remove the drive blank.
2. Install the uFF drives in the SFF flash adapter.
3. Install the SFF flash adapter by pushing firmly near the left-side adapter ejection handle until the latching spring engages in the
drive bay.
To Next Page
Loading...
