To Next Page

To Previous Page

DescriptionItem

start up the storage system, HBA, or switch. When the transfer speed is not

the maximum speed, select the maximum speed from the list on the right or

remove and reinsert the cable.

Only 10 Gbps can be specified for the FCoE port. Auto cannot be specified

for the FCoE port.

Select the address of the selected port. Do not need to set the address to

the FCoE port.

Address (Loop ID)

Select whether a fabric switch is set to ON or OFF. Only ON can be

specified for the FCoE port.

Fabric

Select the topology.Connection Type

• FC-AL: Fibre channel arbitrated loop

• P-to-P (point-to-point). Only P-to-P can be specified for the FCoE port.

Caution: Some fabric switches require that you specify point-to-point

topology. If you enable a fabric switch, check the documentation for the

fabric switch to determine whether your switch requires point-to-point

topology.

Edit Ports Confirm window

Confirm proposed settings, name the task, then click Apply. The task will be added to the execution

queue.

Selected Ports table

DescriptionItem

Identifier of the port.Port ID

Attribute of the port indicating I/O flow.Attribute

• Initiator: Issues I/O commands to a target port when I/O is executed

between storage systems with Continuous Access Synchronous, and so

on.

• Target: Receives I/O commands from a host.

406 LUN Manager GUI reference

HP XP7 User Manual

Other manuals for HP XP7