Table 5-6 Solid-state drive descriptions and part numbers (continued)
Description Spare part number
512 GB, PCIe-4×4, TLC, for use in the People's Republic of China N77393-001
Solid-state drive thermal pads N19245-001
Before removing the SSD, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 41).
2. Remove the service cover (see Service cover on page 41).
3. Disconnect the battery cable from the system board (see Battery on page 42).
Remove the SSD:
1. Use the release tabs (1) to remove the SSD shield (2) from the system board.
The SSD shield is included in the Bracket Kit, spare part number N50688-001.
2. To remove an SSD from slots 2 or 4, remove the Phillips M2.0 × 2.5 broadhead screw (1) that secures
the drive to the system board. The drive tilts up (2).
3. Slide the drive (3) away from the slot at an angle.
NOTE: SSDs are designed with a notch (4) to prevent incorrect installation.
52
Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
