4. To remove an SSD from slots 1 or 3, first remove the drive from slots 2 or 4.
5. Remove the Phillips M2.0 × 2.5 screw (1) from the left side of the retention cover and the Phillips M2.0
× 2.5 screw (2) from the middle of the retention cover.
6. Swing the SSD retention cover (3) up and away from the drive. The drive tilts up.
7. Slide the SSD (4) away from the slot at an angle.
8. The thermal pads are reusable as long as they are not damaged or torn. Take care when removing
or transferring the thermal pad from one SSD to another. The following illustration shows the
replacement thermal material locations.
Thermal pads are used on the SSDs installed in slots 1 and 3.
Solid-state drive
53
To Next Page
Loading...
