4. Release the camera module cable and the wireless antenna cables from the retention clips (4) built
into the fan.
5. Remove the WLAN module plate (1).
The WLAN module plate is included in the Plastics Kit, spare part number N19226-001.
6. Disconnect the wireless antenna cables (2) from the WLAN module.
NOTE: Computer models have either one or two WLAN antennas. On models with two antennas,
the #1 WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2 WLAN antenna
cable connects to the WLAN module #2 Aux terminal.
7. Disconnect the display panel cable (3) from the system board.
8. Release the display panel cable and the wireless antenna cables from the retention clips (4) built
into the fan.
82
Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
