12. To remove the webcam cable:
a. Remove the display assembly.
b. Remove the display bezel.
c. Remove the display panel assembly.
d. Release the LIF connector (1) the webcam cable is connected to, and then disconnect the
webcam cable from the sensor board.
e. Release the LIF connector (2) the webcam cable is connected to, and then disconnect the
webcam cable from the webcam.
f. Remove the webcam cable (3).
The webcam cable is available using spare part number N10934-001.
13. To remove the webcam:
a. Remove the display assembly.
b. Remove the display bezel.
56
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
