HPE ProLiant DL325 Gen10 - Page 97

4. Proceed to Preparing the server for operation on page 97.
Preparing the server for operation
Procedure
1.
Install any options or cables previously removed to access the TPM connector.
2.
Install the access panel.
3.
Install the server into the rack.
4.
Connect the power cords to the server.
5.
Power up the server.
Enabling the Trusted Platform Module
When enabling the Trusted Platform module, observe the following guidelines:
• By default, the Trusted Platform Module is enabled as TPM 20 when the server is powered on after installing it.
• In UEFI Boot Mode, the Trusted Platform Module can be configured to operate as TPM 20 or TPM 12.
• In Legacy Boot Mode, the Trusted Platform Module configuration can be changed between TPM 12 and TPM 20, but
only TPM 12 operation is supported.
Enabling the Trusted Platform Module as TPM 2.0
Procedure
1. During the server startup sequence, press the F9 key to access System Utilities.
2. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration (RBSU) > Server
Security > Trusted Platform Module options.
3. Verify the following:
Hardware options installation 97