Procedure
1. Power down the server.
2. Do one of the following:
• Disconnect each power cord from the power source.
• Disconnect each power cord from the server.
3. Do one of the following:
•
Extend the server from the rack.
• Remove the server from the rack.
4.
Remove the access panel.
5. If a tertiary riser cage is not installed, perform the following steps:
a. Remove the serial port blank.
b.
Insert the serial cable through the blank port and connect it to the system board.
c.
Insert the serial port connector and fasten it to slot 6.
d. Route the cable around the riser cage screws.
e. Remove the double-sided backing and secure the cable to the side of the power supply cage.
Hardware options installation
139
To Next Page
Loading...
