a. Disconnect the SATA cables from the M.2 SSD enablement board.
b. Open the slot cover retainer and remove the failed M.2 SSD enablement board.
To replace the component, reverse the removal procedure.
Front I/O assembly
To remove the component:
1. Do one of the following:
• For tower models, open and remove the tower bezel.
• For rack models, if installed, remove the security bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server .
4. Do one of the following:
38 Front I/O assembly
To Next Page
Loading...
