• For tower models, place the server on a flat, level surface with the access panel facing up.
• For rack models, extend the server from the rack.
5. Remove the access panel.
6. Remove the air baffle.
7. Remove the fan cage.
8. Disconnect the front I/O cable from the system board. For more information, see "System board
components."
9. Release the front I/O cables from the cable clips.
10. Remove any installed device or cable from the USB port.
11. Remove the front I/O module assembly.
To replace the component, reverse the removal procedure.
Hot-plug power input module
To remove the component:
1. If only one power input module is installed:
Hot-plug power input module 39
To Next Page
Loading...
