Item Component Status Definition
Flashing white Ejection request pending.
Do not remove the drive.
Off Drive removed from the
PCIe bus and can be
ejected.
4 Power LED
Solid green Drive is powered on and
configured in system.
Do not remove the drive.
Flashing green Ejection request pending.
Do not remove the drive.
Off Drive removed from the
PCIe bus and can be
ejected.
5 Power button — Momentary press to
request drive removal
from PCIe bus and
ejection. Drive removal
request can be denied by
operating system.
6 Do Not Remove button — Releases the release
lever for removal and
insertion.
Upon NVMe SSD insertion, an LED initiation sequence will be visible - lighting each LED in the carrier in
sequence from left to right. The sequence will cycle until the drive is recognized by the system. When the
SSD is recognized by the system - the Do Not Remove LED will be solid white and the Power LED will be
solid green.
Hot-plug fans
The server supports redundant hot-plug fans to provide proper airflow to the system when a primary fan fails.
CAUTION:
To avoid damage to server components, a fan or fan blank must always be installed in fan bay 1.
CAUTION:
To avoid damage to the equipment, do not operate the server for extended periods of time if the server
does not have the optimal number of fans installed. Although the server might boot, Hewlett Packard
Enterprise does not recommend operating the server without the required fans installed and operating.
Fan numbering
Hot-plug fans 99
To Next Page
Loading...
