HPE ProLiant ML350

Item LED Status Definition
Flashing amber/green The drive is a member of one or
more logical drives and predicts
the drive will fail.
Flashing amber The drive is not configured and
predicts the drive will fail.
Solid amber The drive has failed.
Off The drive is not configured by a
RAID controller.
The blue Locate LED is behind the release lever and is visible when illuminated.
IMPORTANT:
The Dynamic Smart Array B140i Controller is only available in UEFI Boot Mode. It cannot be enabled in
Legacy BIOS Boot Mode. If the B140i controller is disabled, drives connected to the system board Mini-
SAS connectors operate in AHCI or Legacy mode. Under this condition:
• The drives cannot be a part of a hardware RAID or a logical drive.
• The Locate, Drive status, and Do not remove LEDs of the affected drives are disabled.
Use BIOS/Platform Configuration (RBSU) in the UEFI System Utilities to enable or disable the
B140i controller (System Configuration
®
BIOS/Platform Configuration (RBSU)
®
System Options
®
SATA Controller Options
®
Embedded SATA Configuration).
NVMe SSD components
Item Component Status Definition
1 Release lever — Ejects the NVMe drive
carrier from the cage.
2 Activity ring LED
Rotating green
Off
Drive activity
No drive activity
3 Do Not Remove LED
Solid white Drive is powered on and
configured in system.
Do not remove the drive.
Table Continued
98 NVMe SSD components