2. If the battery socket design has a plastic outer lip to secure the battery, insert the battery with the "+" side
facing up underneath the outer lip of the socket, and then press the battery down to secure it in place.
3. Install the access panel.
4. Do one of the following:
• If the server is in a tower configuration, return the server to an upright position.
• If the server is in a rack configuration, slide the server into the rack.
5. Connect each power cord to the server .
6. Connect each power cord to the power source.
7. Power up the server.
8. Do one of the following:
• For tower models, install the tower bezel.
• For rack models, install the security bezel.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.
SAS Expander card
To remove the component:
1. Do one of the following:
• For tower models, open and remove the tower bezel.
• For rack models, if installed, remove the security bezel.
2. Power down the server.
3. Remove all power:
60 SAS Expander card
To Next Page
Loading...
