9. If the system battery is secured by a plastic outer clip, do the following:
a. Use a small flat-bladed, nonconductive tool to carefully lift the front of the battery from the socket.
b. Remove the battery.
IMPORTANT:
Replacing the system board battery resets the system ROM to its default configuration. After
replacing the battery, use BIOS/Platform Configuration (RBSU) in the UEFI System Utilities to
reconfigure the system.
To install the component:
1. If the battery socket design uses a metal tab to secure the battery, insert the battery with the "+" side
facing up on the socket, and then press the battery down to secure it in place.
Removal and replacement procedures 59
To Next Page
Loading...
