HPE ProLiant ML350

Connector Description
3 2x20-pin System board signal cable connector
4 2x12-pin System board power cable connector
5 2x4-pin System board power cable connector
6 Drive boxes 1, 2, 3 (LFF configuration) or 4, 5, 6 (SFF configuration) backplane power
cable connector
• x4 power supply backplane
Connector Description
1 GPU Power cable connector (optional)
2 GPU Power cable connector (optional)
3 Drive boxes 1,2,3 backplane power cable connector
4 Drive boxes 4,5,6 backplane power cable connector
5 2x4 System board power cable connector
6 2x12 System board power cable connector
7 2x20 System board signal cable connector
8 GPU Power cable connector (optional)
9 GPU Power cable connector (optional)
Device numbering
With optional drive cages installed, the server supports up to 48 SFF drives or up to 24 LFF drives. The
server does not support mixing SFF and LFF drives.
Hewlett Packard Enterprise recommends that you populate drive bays starting with the lowest SAS or SATA
device number. Drives are numbered from left to right or bottom to top in each component box.
• 48 SFF drives
◦ Tower orientation
90 Device numbering