• Server Incorrect Address Or Protocol: The backup application will validate input. If this message
occurs, check the backup application configuration.
• Object Extent or Offset Invalid: The backup application tried to copy a backup incorrectly. Check the
backup application setup.
• Object Changed Whilst Queued or Paused: Check the backup policy; their backup application is
making changes to StoreOnce Catalyst items when it should not. Try the copy again within the backup
application.
• Object Not Ready: Contact Hewlett Packard Enterprise Support.
• Job State Inconsistency Found: Contact Hewlett Packard Enterprise Support.
A job may have been paused for the following reasons:
• Link failure: The network between the appliances is down. Check the network connectivity. Once the
connection is re-established, the copy will automatically continue.
• Shutdown: The source or destination appliance was shutdown. Once the appliance is back online, the
copy will automatically continue.
• Blackout window: A blackout window is in effect on the source appliance. Once the blackout window
expires, the copy will automatically continue.
• Server Too Busy: The source or destination appliance is too busy to run the copy job. When
resources are available, the copy job will be automatically restarted.
• System shutdown: The system has been shut down.
116 StoreOnce Catalyst functions
To Next Page
Loading...
