HPE StoreOnce 6500

Library and device details parameters
Library parameters (top half of page)
Table 8: Library parameters
Parameter Description
Name Identifies the selected device (library). Hewlett Packard Enterprise
recommends using a name that identifies the host or backup job with which it
is associated.
Replication Role The role of the library, which may be non-replicating, replication source or
replication target.
Status The status of the library, which may be online, offline, not started, failed to
start, stopping, creating, port not present, or deleting.
Connection Indicates whether the library is connected. Possible values are: Connected –
A client device is connected to any device (robotics or drive) within this
library. Not Connected – No device is connected to this library.
Device Type The emulation type used by the backup software. It is selected when you
create a device.
Cartridges/Slots The number of cartridges or slots available on the device, which is
determined by the Emulation Type selected when the device was created;
see Emulation types for tape devices on page 30. You can reduce the
number of slots in the Device Details tab for a library selected on this page,
but this reduction only removes the highest empty slots. Once it reaches a
slot number that contains data, you cannot reduce the number further on this
page, even if earlier slots are blank. First use the Cartridges tab to make the
slot empty.
Port Identifies the port to which the host is connected for backup and restore. The
number of ports available in the drop-down menu depends upon the
interfaces that your model supports and your network configuration.
User Data Stored The amount of user data stored on the library.
Size On Disk The actual size used on disk (after deduplication).
Dedupe Ratio The deduplication ratio achieved on the data on the library. If deduplication is
disabled, the column displays “Dedupe Disabled.”
Service Set The service set to which the library belongs.
Device details parameters (bottom half of page)
The Device Details tab displays device-specific information for the selected library.
Users with an administrator login may perform the following tasks from this tab:
Library and device details parameters 23