You can also view details about specific optional hardware licenses, and you can activate your optional
hardware licenses.
For 6500 Systems:
Optional hardware is not supported on 6500 Systems. However, if adding a StoreOnce 6600 couplet to a
6500 cluster, 2 x 8 Gb Fibre Channel cards must be installed in the Optional Hardware PCIe slots of each
node of the StoreOnce 6600 couplet.
For 6600 Systems:
• Two PCIe slots (5 & 6) may be configured according to backup environment requirements.
• Network and Fibre Channel cards must be installed in pairs (two Fibre Channel cards or two network
cards). Available options are 10 GbE SFP Network cards, 8 Gb Fibre Channel cards, or 16 GbE Fibre
Channel cards.
• The DIMM modules must be installed in both nodes of a couplet.
• The optional hardware configuration must be the same for all couplets in a cluster.
Table 57: Flexible network and Fibre Channel configuration options
Product Name Optional PCIe slots Card choices
StoreOnce 6600 Systems
2 per node 10 GbE SFP Network
8 Gb Fibre Channel
16 Gb Fibre Channel
Table 58: Memory DIMM modules
Product Name DIMM Quantity
StoreOnce 6600 Systems DIMM, 32 GB PC4-2133P-R, 2Gx4 32
Validating new licenses and updating controller card status
After adding a license on the License Management page, validate your new license on the related
hardware from the Optional Hardware page. If you have new licenses to add before validating the
installed hardware configuration, click Licensing Page at the top of the Optional Hardware
Configuration page.
Procedure
1. In the Navigator pane, select Optional Hardware.
2. An information box states that if any licenses have been added, validate them from this page to update
the controller card status information. Click OK.
3. In the top right corner of the Optional Hardware Configuration page, click Validate. The licenses
you have applied using the Licensing Page will be scanned for pairing with the hardware
components. Clicking Validate will also revalidate all previously installed and configured current
controller cards.
4. Click Activate.
Validating new licenses and updating controller card status 195
To Next Page
Loading...
