HPE StoreOnce 6500

Field name Description
Configuration Information
Frame size This defines the amount of data contained in an Ethernet frame, the default is
1500 bytes. Larger size frames, often referred to as "Jumbo" frames, can
improve performance of the Port Set. Use this field to increase or decrease
the value, which must be an integer between 1280 and 9000.
IMPORTANT: Other devices on the network (clients and switches)
must also be configured to enable Jumbo frames for transfer of frames
larger than 1500 bytes to be possible and to avoid packets fragmenting
or dropping.
Speed The speed of the Port Set, either 1Gbit or 10Gbit, depending on which ports
have been assigned.
Subnet Ports
Name The name of the Subnet
VLAN The VLAN tag ID for the Subnet
Gateway IP The IP address of the gateway
Network Mask The network mask
Domain Name The domain name
Default Subnet Indicates whether this is the Subnet that contains the default gateway
Node tab A node tab contains IP address parameters that are specific to the node.
There may be up to eight node tabs.
Physical IP address and
Virtual IP address on a
Node tab
The IP address(es):
Two IP addresses per node on physical LANs and up to 128 IP addresses for
VLANs across all nodes.
Encryption Links
Client IP address The customer-provided IP address that is being used to add an encryption
link configuration to the subnet.
PassPhrase The pass phrase added when encryption was set up. To delete an encrypted
configuration, you will need this passphrase.
Editing a custom configuration
You cannot edit the current or the Factory_Default_Configuration. However, you can edit any
configuration in the Custom configuration list. If the StoreOnce CLI wizard was used to configure the
network at installation, there will be at least one custom configuration in the list, net_wizard.
Editing a custom configuration 211