Table 15: Source appliance parameters
Source Appliance tab
(no fields are editable).
Appliance Name The name of the Source Appliance.
Product Class The product class of the appliance, such as 3540.
Appliance Address The virtual address of the service set.
Serial Number The serial number of the Source Appliance.
Available Indicates whether the Source Appliance is available or not.
User Data Stored The amount of data stored on the Source Appliance.
Capacity Shows the capacity of the Source Appliance.
Free Space Shows the amount of free space on the Source Appliance.
Software Version Shows the software version of the Source Appliance.
System Time The day of the week and local time (in 24–hour time) of the system. The
system time is set using the CLI time commands; see the StoreOnce
System CLI Reference Guide for details.
Blackout Windows Any blackout windows that have been specified will be reflected in this
weekly calendar. During these times, the selected Source Appliance is not
available for replication.
Throttling (Kbps) The throttling (bandwidth limiting) setting. See Bandwidth Limiting tab on
page 62 for details.
Source Appliance Permissions tab
Source Appliance Permissions are disabled by default. In this state, there is no control over mapping
between share and library devices on the Target and the Source Appliances.
This tab contains an Enabled check box that, when selected, allows administrators to lock the ability to
create share and library mappings. When the Replication wizard is run and mappings are configured, the
Target will only have access to a list of sources that are allowed to replicate to it.
The tab also incorporates a wizard that becomes active when an administrator adds a new source
appliance to list, as described in the procedure below.
To configure access permissions to source appliances (administrators only)
Procedure
1. Click Edit and check the Enabled box.
2. Click Update.
3. A wildcard entry in the Source Appliances list allows configuration of permissions across all source
appliances. However, this does not set permissions for individual appliances.
Source Appliance Permissions tab 59
To Next Page
Loading...
