HPE StoreOnce 6500

• Creating a library (administrators only)
• Editing library details (administrators only)
• Deleting a library (administrators only)
• Make Replication Target libraries visible to the host
Table 9: Device Details parameters
Field Description
Basic Details
Library Name The name used to identify a particular library. Enter a name that identifies
the host or backup job with which it is associated.
Creation Time The date the library was created is generated automatically.
Media Changer Port
Identifies the port type (for example, Fibre Channel).
Deduplication Enables deduplication if the check box is selected (default); unselect to
create a non-deduplication library. Deduplication cannot be enabled or
disabled once the library is created.
Encryption Enabled Enables encryption of data stored in the library. This feature requires a
StoreOnce Security Pack license before encryption can be enabled.
Encryption cannot be enabled or disabled once a library is created; it can
only be enabled at library creation. If enabled, encryption is performed
before writing data to disk for this library.
Secure Erase Mode Enables Secure Erase. This feature requires a StoreOnce Security pack
license before it can be enabled. To enable, select the number of preferred
Overwrite Passes for deleted data (1, 3, 5, or 7 — The default selection of
“None” disables secure erase).
You cannot select Secure Erase while creating a library, but after the
library is created, you can activate this feature if you have a Security pack
license.
See Security features for information about the Secure Erase feature.
Table Continued
24 VTL (Virtual Tape Libraries)