HPE StoreOnce 6500

Field Description
Physical Data Size Quota This quota is for the amount of data written to disk after deduplication. The
minimum quota size is 50 GB. If the quota is enabled and the quota limit is
reached, backups will fail to prevent the quota from being exceeded. The
quota allows you to partition the physical capacity of the appliance
between various users.
NOTE: If capacity management is required, Hewlett Packard Enterprise
recommends configuring backup applications with quotas to reroute to
another device or to postpone backups to prevent backups from failing
unexpectedly.
When a library reaches its quota, the status of the library will change to
“Critical”. Restores from that library are permitted but new backups will
fail. When the quota is no longer met, either by increasing the quota or by
expiring backups, the library status returns to the “OK” state.
Logical Data Size Quota This quota is for the amount of data a user sends to the device before
deduplication. The minimum quota size is 50 GB. If the quota is enabled
and the quota limit is reached, backups will fail in order to prevent the
quota from being exceeded. This allows you to provide a service to back
up a particular amount of user data. For example, set this quota when you
charge customers per TB of user data protected.
NOTE: If capacity management is required, Hewlett Packard Enterprise
recommends configuring backup applications with quotas to reroute to
another device or to postpone backups to prevent backups from failing
unexpectedly.
When a library reaches its quota, the status of the library will change to
“Critical”. Restores from that library are permitted but new backups will
fail. When the quota is no longer met, either by increasing the quota or by
expiring backups, the library status returns to the “OK” state.
Emulation
The StoreOnce appliance supports HPE and IBM Library and drive emulations.
Library Emulation The emulation type of the library. The StoreOnce System supports a
number of emulation types.
See also Emulation types for tape devices on page 30. The emulation
type determines the available embedded drives and cartridge slots. For
example, if you select MSL G3 Series (2x24), the device emulates an MSL
2024 Library with two embedded tape drives and a possible total of 24
cartridge slots. Consult your backup application technical support
information for information about device types they support.
Table Continued
VTL (Virtual Tape Libraries) 25