HPE StoreOnce 6500

Procedure
1. From the Navigator, select Device Configuration > SNMP.
2. Select the trapsink from the SNMP Trapsinks list.
3. View additional details about the selected trapsink in the Trapsink Details pane at the bottom of the
GUI page.
Table 51: SNMP Trapsinks parameters
Name Description
Trapsink Address The IP address of the host that is to receive SNMP traps.
Version The version of the trapsink (1, 2, or 3).
Port The port number of the host.
State The state of the trapsink (off, on).
Table 52: SNMP Trapsink Details parameters
Name Description
Trapsink Address The IP address of the host to receive SNMP traps.
Version The version of the trapsink (1, 2, or 3, default is 1).
Port The port number of the host.
State The state of the trapsink (off, on).
Community (version 1 and
2 only)
The community string can be set by the network manager (default is
public).
User Name (version 3
only)
The user name assigned to this trapsink.
Auth Algorithm (version 3
only)
The user authentication algorithm used to authorize messages sent or
received on behalf of the listed user (MD5 or SHA, default is MD5).
Optional.
Priv Algorithm (version 3
only)
The SNMP version 3 privacy algorithm used to encrypt messages sent
or received on behalf of this user (DES or AES, default is DES).
Optional.
Context Name The name of the SNMP context. (SNMP context is a collection of
management information accessible by an SNMP entity.) Optional.
180 Access and Device Configuration