HPE XP7

Screen element Description
CA Link Status Failed or Active.
NOTE: When Continuous Access is configured as Sync or
Async and the selected volume type is SVOL, then you
might encounter the CA Link status as NA - Not
Applicable.
Pair Status Alarm Alarm configuration for the CA pair status. PA retrieves the CA
pair status during each performance cycle. If there is a change in
the pair status from the previous performance cycle, an email
notification is sent to the email address specified on the Email
Settings screen. These notifications are not sent if there is an
intermediate change in the pair status during a performance
cycle.
You can enable/disable the Pair Status Alarm option. To apply
the changes, click Actions > Apply Settings.
No. of Paths The physical transmission link between the local and remote
systems is called the data path. PA displays the number of active
Continuous Access paths from a PVOL to SVOL.
NOTE: When Continuous Access is configured as Sync or
Async and the selected volume type is SVOL, then you
might encounter the status of the number of paths as NA -
Not Applicable.
Fence Level Fence level of target device (Pair volume). Displays one of the
following:
• ASYNC for asynchronous communications
• DATA, STATE, or NEVER for synchronous communications
• JNL for Continuous Access journal based transactions
JNL-ID Journal ID of the journal Group associated with the P-VOL or S-
VOL. The column value includes the journal ID and mirror ID on
which the CA-J pair is created. Example: jnl ID:mirror ID
CTG-ID CTG ID, which guarantees consistency in the sequence of
asynchronous data transfers for a remote copy volume Group.
P-VOL Host Port Host port assigned for the P-VOL.
S-VOL Host Port Host port assigned for the S-VOL.
CLPR CLPR based on the associated volume type (P-VOL or S-VOL)
manages cache for the Continuous Access transactions.
Table Continued
210 Summary view