HPE XP7

Types of reports
Reports in PA provide a high level performance view of the XP and XP7 disk arrays, and the utilization of
individual components in these disk arrays. Each report includes the 50th, 90th, and 95th percentile
values as legends in the charts. For more information on percentile values, see View 50th, 90th and 95th
percentile value in charts. Following are the different reports that you can view in PA. The Yes and No
given under For XP disk arrays and For XP7 disk arrays columns indicate whether that particular report is
displayed for the XP7 disk array:
Report
types
Description For XP disk arrays For P9500/XP7 disk
arrays
Array
Performanc
e
The Array Performance report provides the
overall array performance by measuring
the total I/Os, read and write I/Os on that
array. The Array Performance report
comprises of the following reports:
• Total I/O Rate
• Total I/O Rate by hour of day
• Total I/O Rate Detail
• Read-Write Ratio
• Read-Write Ratio by hour of day
• Read-Write Detail
• Max/Min Frontend Port IOPS
• Max/Min Frontend Port MB/s
In addition, it includes a section called
Findings at the beginning of the report.
Yes
The Findings section
provides a brief summary
on the status of the CHIPs,
cache, ACP, and the
LDEVs.
Yes
• The Findings
section provides a
brief summary on
the status of the
cache, LDEVs, and
the MP Blades.
• The utilization
summary of the
CHIP/CHA and
ACP/DKA MPs are
not displayed in the
Array Performance
report - Findings
section.
ACP
Utilization
The ACP Utilization report provides data
on the utilization of various installed
ACP/DKA pairs for the duration that you
specify. You can also view the ACP
Utilization by Hour of the Day report that
provides the utilization data for all the
ACP/DKA pairs averaged over a 24-hour
period.
Yes No
Table Continued
264 Types of reports