hpmont HD30 Series - Group F20 Protection of Fault Parameters

Appendix A Parameters Shenzhen Hpmont Technology Co., Ltd
―122― HD30 Series Inverters User Manual
No. Name Range
Factory
Default
Unit
Modified
attributes
Setting
checking
4: Incorrect data frame
content
d00.53 Actual length 0－65535m *
d00.54 Total length 0－65535m *
d00.55 Total power-on time (h) 0－65535h *
d00.56 Total operation time (h) 0－65535h *
d00.57
High bit of total motor
energy depletion
0－65535k kW.h *
d00.58
Low bit of total motor
energy depletion
0.0－999.9kW.h *
d00.59
High-energy running
this time
0－65535k kW.h *
d00.60
Low-energy running
this time
0.0－999.9kW.h *
d00.61 Fault at the moment 1－99 *
Group d01 Reserved
Group d02 Water Control Status Parameters (refer to pages 54
－
55)
d02.00 Current time (hours) 00.00－23.59 *
d02.01 Pump 1 status
0: At rest
1: Run
2: Fault
*
d02.02 Pump 2 status *
d02.03 Pump 3 status *
d02.04 Pump 4 status *
d02.05 Pump 5 status *
d02.06 Pump 6 status *
d02.07 Pump 7 status *
Group F: General Function Parameter (refer to pages 55
－
109)
Group F00 Basic Parameter (refer to pages 55
－
57)
F00.00 Reserved
F00.01 Control mode selection
0: V/f control without PG
1: Reserved
2: Vector control without PG
0 1 ×
F00.02 Inverter type setting
0: G type
1: P type
0 1 ×
F00.03 Motor selection
0: Motor 1
1: Motor 2
0 1 ×
F00.04
HD30 general
extension option
selection
0: Option is invalid
1: HD30-EIO is valid
2: HD30-WIO is valid
3: HD30-PIO is valid
0 1 ×
F00.05
HD30 extension
application function
0: No extension application
1: Water and wastewater
0 1 ×