What does Lu error mean on hpmont HD5L-4T3P7?
The Lu error on the hpmont Controller indicates DC bus undervoltage. This can be normal during power on and power off. Check the input power voltage and ensure the HD5L wiring is correct.
What to do if hpmont HD5L-4T3P7 Controller shows E0004 error?
If the hpmont Controller displays error E0004, which indicates Acc over voltage, you should check the power input, set a proper value for Dec time, and check wiring to ensure HD5L is wired properly.
What to do if hpmont Controller displays E0020 error?
If the hpmont Controller displays error E0020, indicating motor overheat, reduce the load, increase the Acc / Dec time, repair or replace the motor, detect whether the overheat detection input signal is correct, and set the motor parameter according to nameplate.
What to do if hpmont HD5L-4T3P7 displays E0032 error?
If the hpmont Controller displays error E0032, indicating motor over speed, set proper PG pulse number, select bigger capacity controller, and correctly set speed-loop PI parameter.
What to do if hpmont HD5L-4T3P7 Controller displays E0016 error?
If the hpmont Controller displays error E0016, which indicates output voltage phase loss, check the connection between HD5L and the motor and check the quality of the motor.
Why hpmont Controller shows E0018 error?
The E0018 error on the hpmont Controller indicates excessive speed deviation. To fix it, change the contactor, set proper PG P/R, correct the setting of F05.19 - F05.20, select bigger capacity, and correctly set speed-loop PI parameter.
What to do if hpmont HD5L-4T3P7 displays E0025 error?
If the hpmont Controller displays error E0025, which indicates too small running current, correct the setting of F16.14, F16.15, check the connection between HD5L and motor, detect HD5L whether output and detect whether the output contactor work is normal.
What to do if hpmont Controller displays E0023 error?
If the hpmont Controller displays error E0023, which indicates a faulty setting of parameters, select a controller with a suitable power rating and set correct value of motor parameters.
What to do if hpmont Controller displays E0008 error?
If the hpmont Controller displays error E0008, which indicates a power module fault, check the connection and connect the wire properly and check the connection and mechanism.
What to do if hpmont HD5L-4T3P7 shows E0009 error?
If the hpmont Controller displays error E0009, which indicates a heatsink overheat, consider using a controller with a higher power capacity, improving the ventilation around HD5L, or replacing the cooling fan.
General| Brand | hpmont |
|---|---|
| Model | HD5L-4T3P7 |
| Category | Controller |
| Language | English |
Details restrictions on output side components, voltage, input phases, and derating.
Lists electrical, performance, and protection specifications of the controller.
Provides a table of model ratings for single-phase and three-phase power supply.
Lists essential safety precautions that must be followed during installation.
Specifies environmental and spatial requirements for the installation location.
Outlines critical safety rules and precautions for electrical wiring.
Recommends peripheral devices for the main circuit based on model specifications.
Details the main circuit terminals and provides general wiring guidelines.
Discusses control circuit safety, cable management, and interference suppression.
Introduces different types of encoder cards and their respective functions.
Explains how to ensure Electromagnetic Compatibility (EMC) during installation.
Explains the step-by-step process for motor parameter auto-tuning.
Describes the battery-driven run mode for emergency situations during power outages.
Lists common fault codes, their possible reasons, and recommended countermeasures.
Lists fault protect parameters and their attributes.
To Next Page
