To Next Page

To Previous Page

400 Series

EN - 56

CAUTION

Possible additional earth connections could influence the measured value.

For the difficulty of this measurement and the sometimes real difficulty in

removing the clamps, we recommend performing the measurement

indirectly.

Press the GO/STOP key. The instrument stops

updating the measured value and STOP

appears on the right bottom part of the display.

Press the same key again to restart the

measurement and the real-time display of the

instant value of the input parameter. In this

case, RUN appears on the right bottom part of

the display

LEAK

I = 47.0 A

Imax = 86.4 A

100A

STOP

The results displayed can be saved, both in RUN and in STOP mode, by

pressing the SAVE key twice or the SAVE key and, subsequently, the

ENTER key (§ 8.1)

6.9.1. Description of anomalous results

1. If the instrument detects that

the current is higher than the

one of the set full scale, the

screen on the side will be

displayed. Check that the full

scale selected on the

instrument matches the full

scale on the transducer

LEAK

I > 100.0 A

Imax > 100.0 A

Measured value higher than the

instrument’s full scale

100A

RUN

The results displayed can be saved by pressing the SAVE key twice or the

SAVE key and, subsequently, the ENTER key (§ 8.1)

Questions and Answers:

Need help?

Do you have a question about the HT 400 Series and is the answer not in the manual?

HT 400 Series Specifications

General