400 Series
EN - 60
8.2. SAVED DATA MANAGEMENT
1.
Press the MENU key, move the cursor to MEM
in the main menu by means of the arrow keys
(,) and confirm with ENTER. Subsequently
the instrument displays a screen similar to the
one reported here to the side where the
following are listed:
MEM the occupied memory location
TIPO the kind of measurement performed
P the P parameter value
L the L parameter value
The different performed measurements are
displayed in rising cell order (from the oldest to
the most recent one). The number of used
memory cells and the number of available
locations is also displayed
MEM
MEM TIPO P L
001 LOW 110 096
002 LOW 110 096
003 LOW 110 096
004 LOW 110 096
005 LOW 110 096
006 LOW 110 096
007 LOW 110 096
TOT:392 FREE:108
TOT
REC PAG CANC
2.
Use the , keys to select the parameter to be modified, and the , keys
to modify the parameter value.
REC
The virtual REC key scrolls down the measurements displayed one
by one thus allowing the selection of the one to be recalled
PAG
The virtual PAG key scrolls down the measurement displayed in
each page (by groups of 7 measurements) thus allowing a faster
selection of the measure to be recalled
CANC
The virtual CANC key allows deleting the last or all the measures
stored in the memory. Following options are available: ULT, TOT
8.2.1. How to recall a measure
3.
By means of the REC and PAG virtual keys
select the measure to display. Pressing the
ENTER key the instrument will display the
selected measure and its info
RCD
0° 180°
x1/2 >999ms >999ms
x1 28ms 31ms
x5 8ms 10ms
FRQ=50.0Hz Ut=1.4V
VP-N=228V VP-Pe=228V
RCD OK
AUTO 30mA 50V
Func IdN RCD UL
4.
Press the ESC key to go back to the saved measures list
5.
Press the ESC key to go back to the the main menu
To Next Page
Loading...
Need help?
General
