To Next Page

To Previous Page

400 Series

EN - 54

6.8.1. AIR, RH, TMP °F, TMP °C, Lux mode

3. Insert the connector of the probe being used into the instrument input In1 making sure

that the probe connected and the set measurement unit correspond

Press the GO/STOP key. The instrument stops

updating the measured value and STOP

appears on the right bottom part of the display.

Press the same key again to restart the

measurement and the real-time display of the

instant value of the input parameter. In this

case, RUN appears on the right bottom part of

the display.

AUX

In1 = 7.08 Lux

Lux LX 20

STOP

Func FS

Measures can be saved, both in RUN and in STOP mode, by pressing the

SAVE key twice or the SAVE key and, subsequently, the ENTER key (§ 8.1)

6.8.2. Description of anomalous results

1. In AIR, RH, TMP °F, TMP

°C, Lux or VOLT mode, if the

instrument measures an

input value higher than the

full scale, it displays a screen

similar to the one reported

here to the side. Check that

the full scale selected on the

instrument matches the full

scale on the transducer

AUX

In1 > 20.00 kLux

Measured value higher than the

instrument’s full scale

Lux Lx 20k

Func FS

The results displayed can be saved by pressing the SAVE key twice or the

SAVE key and, subsequently, the ENTER key (§ 8.1)

The previous anomalous result cannot be saved

Questions and Answers:

Need help?

Do you have a question about the HT 400 Series and is the answer not in the manual?

HT 400 Series Specifications

General