FusionModule800 Smart Small Data Center
Maintenance Guide
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 5-55 Removing the ECC800 main control module
Step 3 Take out the Micro SD card from the card slot, as shown in Figure 5-56.
Figure 5-56 Taking out the Micro SD card
Step 4 Install the spare Micro SD card into the slot.
Step 5 Install the ECC800 main control module in the card slot.
Step 6 Tighten the screws on both sides of the ECC800 main control module.
----End
5.4.8 Replacing a WiFi Module
Prerequisites
Tools: ESD wrist strap, ESD gloves
Materials: A spare WiFi module of the same model is available and functional.
Procedure
Step 1 Remove the faulty WiFi module from the ECC800 monitoring module.
Step 2 Install the new WiFi module in the ECC800 monitoring module.
----End
To Next Page
Loading...
Need help?
General