Huawei FusionServer G5500 - Logging in to the Management Module CLI through the Management IP Address of the Server Node

After login, the host name of the device is displayed on the left of the prompt.
----End
5.3.1.3 Logging In to the Management Module CLI Through the Management IP
Address of the Server Node
Scenarios
Log in to the management module CLI through the iBMC management IP address on the
server node.
Prerequisites
Conditions
The G5500 has been powered on.
Data
l IP address of the iBMC management network port on the server node
l User name and password for logging in to the iBMC of the server node
Software
PuTTY.exe (third-party software)
Procedure
Set the client address.
1 Set the IP address, subnet mask, or route of the client to enable the client to interconnect
with the iBMC management network port on the server node.
On the client, choose Start > Run, enter cmd, and click OK. Then, run the Ping IP
address of the aggregated management network port command to check whether the
management network port is reachable.
Log in to the iBMC WebUI of the server node.
For details, see 5.4.1 Logging In to the iBMC WebUI.
Enable the transparent transmission function.
2 In the navigation tree on the iBMC WebUI of the server node, choose Configure >
Service Settings.
The Service Settings page is displayed.
NOTE
If the iBMC version is earlier than 2.01, the Port Settings page is displayed.
3 Enable HMM SSH NAT and set Port to 30022, as shown in Figure 5-6.
FusionServer G5500 Server
User Guide
5 Configuring the G5500
Issue 02 (2017-12-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
76