Huawei FusionServer G5500 - Checking the Management Module Health Status; Changing the Initial Management Module User Password

ipmcget -d version
The command output is as follows:
iBMC:/->ipmcget -d version
------------------- iBMC INFO -------------------
IPMC CPU: Hi1710
IPMI Version: 2.0
CPLD Version: (U30)0.04
Active iBMC Version: (U1)2.76
Active iBMC Build: 003
Active iBMC Built: 21:11:54 Oct 26 2017
Backup iBMC Version: 2.76
SDK Version: 3.07
SDK Built: 20:23:12 Sep 19 2017
Active Uboot Version: 2.1.06 (Sep 19 2017 - 20:23:38)
Backup Uboot Version: 2.1.06 (Sep 19 2017 - 20:23:38)
IPMB Address: 0x10
----------------- Product INFO -----------------
Product ID: 0x0002
Product Name: MM510
-------------- Mother Board INFO ---------------
Mainboard BoardID: 0x0000
Mainboard PCB: .A
-------------- Backplane INFO ------------------
Chassis BP BoardID: 0x0002
Chassis BP PCB: .A
----End
5.3.2 Checking the Management Module Health Status
Scenarios
Check the management module health status.
Prerequisites
Conditions
l The G5500 has been powered on.
l You have log in to the management module CLI.
Data
The version meets site requirements.
Procedure
Step 1 On the management module CLI, run the ipmcget -d version command to query the
management module version information, and ensure that the version meets site requirements.
Step 2 On the management module CLI, run the ipmcset -d password -v username command to
check the management module health status.
iBMC:/->ipmcget -d health
System in health state.
----End
5.3.3 Changing the Initial Management Module User Password
Change the initial management module user password.
FusionServer G5500 Server
User Guide
5 Configuring the G5500
Issue 02 (2017-12-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
79