Figure 5-7 PuTTY Configuration
5 Set the login parameters.
The parameters are described as follows:
– Host Name (or IP address): Enter the IP address of the management network port,
for example, 10.10.1.104.
– Port: Retain the default value 30022.
– Connection type: Retain the default value SSH.
– Close window on exit: Retain the default value Only on clean exit.
NOTE
After you set Host Name (or IP address) and then Saved Sessions and click Save, you can
simply double-click the saved settings under Saved Sessions to log in to the server.
6 Click Open.
The PuTTY window is displayed. Then the message login as: is displayed, prompting
you to enter a user name.
NOTE
– If you log in to the server for the first time, the PuTTY Security Alert dialog box is
displayed. If you trust this site, click Yes. The PuTTY window is displayed.
– If the entered user name or password is incorrect during server login, PuTTY must be
connected again.
7 Enter the user name and password as prompted.
8 Run the following command to check that Product Name is MM510, which indicates
that the transparent transmission function is configured successfully.
FusionServer G5500 Server
User Guide
5 Configuring the G5500
Issue 02 (2017-12-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
78
To Next Page
Loading...
