Install the holder.
Remove the cable tray.
Install the SS61COA.
Install the cable tray.
When you install the SS61COA inside the cabinet, 125 mm of space is required. By default, the SS61COA is
installed below the lower subrack and is more than 50 mm away from the subrack. The SS61COA can be
installed in a cabinet that is not fully configured with subracks, but future expansion will be affected due to
reduced installation space in the cabinet.
Cable tray
• Installation effectiveness
30±3 Kgf.cm
M6
30±3 Kgf.cm
M6
30±3 Kgf.cm
M6
30±3 Kgf.cm
M6
NOTE
To Next Page
Loading...
Need help?
General
