Huawei OptiX OSN 3500 - Installing RPC Frames; Exterior of the RPC Frame; Installation Holes

20
8
Installing RPC Frames
Exterior of the RPC Frame
a
The RPC frame is powered by the
tributary power output terminal on
the power cable terminal block on
the top of the cabinet. Straight-
through network cables are used for
communications between the RPC
board and the subrack.
If the EXT port on the AUX board is vacant, you can connect the LAN port on the RPC board to the EXT
port on the AUX board using a network cable.
Fan assembly
RPC board
Power module
Installation Procedure
c
2
2
1
1
Phillips screwdriver
Install the mounting ears. Secure the RPC frame on the columns.
B
A
B
A
Holes for installing mounting ears of the
RPC frame in the T63 cabinet
Holes for installing mounting ears of the
RPC frame in the N63E cabinet
Installation Holes
b
30±3 Kgf.cm
M6
12±1.2 Kgf.cm
M4
NOTE
NOTE