Huawei OptiX OSN 3500 - Installing and Routing SDI Coaxial Cables; Ports on the VST4 Board; Installing SDI Coaxial Cables

IN1 OUT1 IN2 OUT2 IN3 OUT3 IN4 OUT4
11
Installing and Routing SDI Coaxial Cables
60
Ports on the VST4 Board
a
Installing SDI Coaxial Cables
b
SDI coaxial cables
Bind SDI coaxial cables using the method
illustrated in the figure on the left side,
because of insufficient cable routing space.
That is, bind cables at ports 1–4 and 4–8,
and then bind cables at ports 1–8.
The description uses cable routing on the
right side as an example. When routing
cables on the left side, use the same
method.
The description uses underfloor cabling as
an example. For overhead cabling, use the
same method.
1
2
3
4
5
6
7
8
The VST4 board provides four separate multi-service access ports, which are applicable to
transparent transmission of four video services.
VST4
VST4
STAT
OUT1
ACT
PROG
SRV
IN1 OUT2 IN2 OUT3 IN3 OUT4 IN4
Front view
Side
View
Ports on the
Front Panel
Type of Port Application
IN1-IN4 SMB (which can be converted to BNC
through a conversion cable)
Receives electrical signals of the DVB-
ASI, SD-SDI, or HD-SDI service.
OUT1-OUT4 SMB (which can be converted to BNC
through a conversion cable)
Transmits electrical signals of the DVB-
ASI, SD-SDI, or HD-SDI service.
NOTE
CAUTION
NOTE