Figure 9-2 Connecting an RPS cable to the RPS1800
Step 3 Connect the RPS cable to a switch.
1. Insert the other end of the RPS cable to the RPS input port at the rear of the switch.
Ensure that the top side of the plug (marked "TOP") faces up.
2. Tighten the captive screws on the plug.
Figure 9-3 Connecting the RPS cable to a switch
Step 4 Connect the RPS1800 power cable to the RPS1800.
The RPS1800 uses a C19 straight female to PI angle male AC power cable, as shown in
Figure 9-4. An RPS1800 power cable is connected in the same way as the AC power cable of
a switch. For details, see 7.1 Connecting Power Cables.
Figure 9-4 RPS1800 power cable
Step 5 Connect the RPS1800 power cable to an external power supply system.
S2700&S3700&S5700&S6700 Switch
Hardware Installation and Maintenance Guide
9 (Optional) Installing an RPS1800
Issue 13 (2017-11-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
72
To Next Page
Loading...
