Huawei UPS2000-G - Page 101

Item Description Defau
lt
Value
Value
Range
Power
segment
Determine whether to enable the power
segment function for a singe UPS. (This
function is not supported in a parallel
system). This parameter is congurable
only after the inverter is shut down.
Disabl
ed
Disabled,
Enabled
● Self-Load screen
Figure 5-32 Self-Load screen
Table 5-23 Self-load settings
Item
Description Defa
ult
Value
Value
Range
Output
power
ratio
This parameter is used only during the
tests before shipment. This parameter is
congurable only after the inverter is
shut down.
80% 20%–
100%
Self-load
mode
This parameter is used only during the
tests before shipment. This parameter is
congurable only after the inverter is
shut down.
Disabl
ed
Disabled,
Enabled
● Others screen
Figure 5-33 Others screen
NO TE
The EPO enable setting is available only for the UPS2000-G-15KRTL-01/UPS2000-
G-20KRTL-01. EPO is enabled for the UPS2000-G-6KRTS/UPS2000-G-10KRTS/
UPS2000-G-15KRTL/UPS2000-G-20KRTL by default.
UPS2000-G-(6 kVA–20 kVA)
User Manual (Lead-Acid Battery) 5 Control Panel
Issue 23 (2024-03-15) Copyright © Huawei Digital Power Technologies Co., Ltd. 93