Pub. 42004-550A
Elemec3 Console Manual—Version 3.0 Page 107 of 114
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-550A.docx
09/20
Network Properties
Network Mode—DHCP or STATIC
Subnet Mask—mask that defines the logical IP network.
Gateway—IP address of the router to access destinations outside the logical IP network.
DNS—IP address for the DNS. DNS converts domain names to IP addresses.
Telnet Locked—Enabled/Disabled
SMTP Setup—System Only
The parameters under this heading are view only parameters that are inherited from the SYSTEM
PROPERTIES screen GLOBAL SYSTEM SETTINGS pane.
SMTP Server—IP address of the SMTP server that will receive email from the E3 system.
SMTP Port—IP port address of the SMTP service. default 25.
SMTP From—sending SMTP address from the E3 system.
SMTP To—address configured to receive email from the E3 system.
SMTP Password—password required to authenticate the SMTP From account on the SMTP server.
SNMP Setup—System Only
The parameters under this heading are view only parameters that are inherited from the SYSTEM
PROPERTIES screen GLOBAL SYSTEM SETTINGS pane.
SNMP Server—IP address of the SNMP server
SNMP Port—IP port address of the SNMP service on the SNMP server.
RTU/RS IO—See the RTU Settings (Excluding SVS) section.
SVS I/O Settings—See the SVS Settings (SVS Only) section.
SP2 Configuration Assets
SP2 configuration assets are multicast sockets, relay groups, and VLC levels that are used throughout the
SP2 configuration in the E3 system.
Multicast Sockets
Multicast sockets are configured for each page and party line:
1. Create additional multicast sockets by clicking the + ADD SOCKET button and entering a description
and a valid multicast socket address.
Valid multicast sockets must have IP addresses and ports in the following range: (239.1–127|129–
255.0–255.0–255: 0–65534).
2. Delete manually created multicast sockets by clicking the – DELETE SOCKET button.
To Next Page
Loading...
